When a furnace stops firing in January or an AC quits in the middle of a Kansas summer, the call that matters is the one that gets somebody out fast. We handle the full range of residential and commercial heating and cooling work across Shawnee: repair, maintenance, system replacement, ductwork, controls, and emergency no-heat and no-cool calls. Every day from 8:00 AM to 9:30 PM, the person who answers knows the trade and can scope the job on the phone before anything is scheduled.
Pricing is confirmed before the visit goes ahead. The diagnostic fee covers the visit and the assessment, and it gives you a clear picture of what the repair or replacement involves. You decide whether to move forward once you have that picture.
Call (816) 962-5932 and we will talk through what the system is doing and what the visit will cover.
HVAC work like this is the bulk of what a season brings, and the situations that trigger a call tend to be specific. A system that ran fine last spring may not start this summer. A furnace that lit without issue last fall may refuse to fire when the temperature finally drops. The jobs below are the ones we take on most often, and each one starts the same way: a call, a conversation about what the system is doing, and a price confirmed before the visit is scheduled.
A home that has never had central air, or one where the existing system has been removed, needs more than just a new unit dropped in place. The installation covers equipment selection sized to the space, the refrigerant circuit, the connection to the air handler, and a full commissioning test before the visit is complete. Airflow balanced rather than left to chance is the standard every installation is held to.
A system that does not respond at all when the thermostat calls for cooling can fail for a handful of reasons, some simple and some not. The diagnostic covers the thermostat signal, the disconnect, the capacitor, the contactor, and the compressor itself. Refrigerant leak diagnosis is part of the process when the pressures point that direction. We confirm what we find before any repair is quoted.
Grinding, rattling, squealing, and banging from an air handler or outdoor unit are not sounds to wait out. Each points to a different fault: a failing blower motor, a loose component, a refrigerant issue, or a compressor that is starting to go. The visit identifies the source before anything is replaced, and we walk through what the repair involves and what it costs before the work starts.
A heat pump that is not producing heat in winter, one that is running in defrost mode continuously, or one that is not cooling in summer are three different problems that share the same equipment. The diagnostic covers the reversing valve, the refrigerant charge, the defrost board, and the outdoor coil. Whether the fault is repairable or whether the system has reached the point where replacement makes more sense is a conversation we have on the visit, with the diagnosis in hand.
A furnace that attempts to light and shuts back down, one that produces a fault code and locks out, or one that simply will not ignite is almost always an ignition or flame sensor issue. The repair is specific: the igniter, the flame sensor, the gas valve, or the control board, depending on what the diagnostic shows. We do not replace parts on a guess. We find it. We fix it. We test the airflow.
A system that was undersized struggled through every season it ran. One that was oversized short-cycled, wore out faster, and never pulled the humidity out of the air properly. Replacing a failing system with the same capacity as the old one repeats whatever mistake was made the first time.
Proper sizing accounts for the square footage of the space, the insulation and window load, the ductwork configuration, and how the building holds and loses heat and cool air. The work matched to the manufacturer's specification is how a replacement is approached, and that starts with understanding what the property actually needs rather than what was already there.
For homes that have had additions, converted spaces, or zones that the original system never properly reached, a full system replacement is also the right time to address those gaps. A zoning system or a ductless mini-split for a problem area can be part of the same project.
Call (816) 962-5932 to talk through what the replacement would involve for your property.
An older thermostat that is reading the room temperature incorrectly, responding slowly, or failing to hold a setpoint will make a perfectly functional system behave as though something is wrong. Before a full diagnostic is scheduled, it is worth knowing whether the control has been ruled out.
A modern programmable or smart thermostat gives the system accurate signals, lets you set schedules around how the property is actually used, and in some cases surfaces fault information that an older control would never show. The installation covers removing the old unit, confirming compatibility with the existing equipment, wiring the new control, and running the system through a full cycle to confirm it is responding correctly.
Thermostat replacement is also worth considering on its own when a system is otherwise in good shape. It is one of the lower-cost upgrades with a real and immediate effect on how the system behaves day to day.
Your home deserves heating and cooling that runs right, and getting there should not mean shutting down a business or displacing a tenant for a day.
No-heat and no-cool situations are treated as urgent calls. When you call during our hours, 8:00 AM to 9:30 PM every day, the visit is scoped on the phone and scheduled from there. We take emergency calls for residential properties, rental units, and commercial spaces across Shawnee and Johnson County. You get told when a repair is not going to hold, and that conversation happens on the visit before any follow-up work is agreed.
For a rental property, a landlord or property manager can call to set up the visit without the tenant needing to be part of the scheduling process. For a business that has to stay open, the scope of the work and what access is needed are confirmed on the call before anything is dispatched. We confirm what the visit covers, what the diagnostic process involves, and what the next steps look like before anyone shows up. For a fuller picture of the job, see our full list of heating and cooling services.
What a repair or replacement costs depends on the system type, the fault, and the scope of the work. A flame sensor replacement is a different job from a full furnace and AC system replacement, and the price reflects that difference.
What moves a quote in either direction is what the fault turns out to be, how much of the system has to be accessed to reach it, and whether a repair is the right answer or whether replacement is the more practical path. No-pressure estimates are priced up front. The rate is confirmed on the call, the diagnostic is explained before any repair is quoted, and the repair is confirmed before it goes ahead.
Do not expect a number before the system has been looked at. Any figure given without a diagnosis is a guess, and a guess is not a quote.
Call (816) 962-5932 and we will scope the job on the phone.
We cover Shawnee and the surrounding Johnson County area for residential and commercial heating and cooling work. If you are in one of the communities nearby, we cover your area too.
Call to confirm coverage for your address and to get a price on the phone. We are open every day from 8:00 AM to 9:30 PM.
Yes. Landlords and property managers can call to schedule a repair or inspection for a rental property without needing to be present themselves. We confirm access arrangements and what the visit covers on the call. The tenant does not need to be part of the scheduling conversation unless you want them to be.
Often yes, but not always. We assess the existing ductwork as part of the replacement process. If the ducts are structurally sound, properly sized for the new equipment, and not leaking significantly, reusing them is the practical choice. If they are damaged, undersized, or heavily leaking, addressing them as part of the replacement produces a better result.
Yes. We work on heating and cooling systems in single-family homes, rental properties, and commercial spaces across Shawnee and the surrounding Johnson County area. The process is the same for each: the job is scoped on the phone, the price is confirmed before the visit is scheduled, and the diagnostic is explained before any repair goes ahead.
First check that the thermostat is set to heat and that the filter is not completely blocked. If those are in order and the system is still not producing heat, the fault is inside the equipment and needs a diagnostic visit. A heat pump that runs continuously without reaching the set temperature in winter often points to a reversing valve fault, a low refrigerant charge, or a defrost control issue.
Call (816) 962-5932 and describe what the system is doing, and we will scope the visit on the phone.
Yes. If a property has both a central system and a ductless mini-split, we can assess both on the same visit. Describe the equipment when you call to schedule so the visit is scoped to cover everything that needs attention.
Both options exist. A whole-home dehumidifier installs inline with the existing HVAC system and handles humidity independently of the cooling cycle. Some systems can also be configured to run the fan independently to help with air circulation and moisture control. We assess the existing setup and explain the options on the call.
A thermostat call is worth making on its own if the system is otherwise working and the issue is clearly with the control rather than the equipment. If the system is also underperforming, short cycling, or making unusual sounds, a full diagnostic covers more ground. Describe the situation when you call and we will advise on the right scope for the visit.
Upfront pricing. Clear diagnosis. Code-compliant work.
Whether the furnace is not firing, the AC is not cooling, or the system is making a noise it was not making last week, call (816) 962-5932.
We handle heating and cooling work across Shawnee and Johnson County, and the visit starts with a conversation that gets the job scoped before anything is scheduled.
Other towns where we take heating and cooling work: Lenexa, Mission, Prairie Village.
See our town-by-town list.
Every heating and cooling job we handle in Shawnee starts the same way: a call, a clear scope, and a price confirmed before anything is scheduled. The table below covers the full range of work we do, who each service fits best, and what is practical to know before you call. Use it to find the right starting point, then reach out and we will walk through the details on the phone.
| Service Type | What the Service Includes | Best For | Helpful Details |
|---|---|---|---|
| AC Repair & Service | Refrigerant level and leak check, Condenser and evaporator coil inspection, Electrical connections at the unit, Airflow and blower performance | Homeowners or property managers with an AC that has stopped cooling or is running but underperforming | Missouri summers push central AC systems hard. A system that is short-cycling or producing warm air from the registers is worth calling about before it fails completely. |
| Seasonal Maintenance & Tune-Ups | Spring AC tune-up before cooling season, Fall furnace tune-up before heating season, Coil, filter, and drain line service, Refrigerant level and ignition check | Any homeowner or property manager who wants to stay ahead of mid-season breakdowns rather than reacting to them | A tune-up costs less than an emergency repair call. It also surfaces small faults, like a low refrigerant charge or a worn igniter, before they compound into a full system failure. |
| Full System Installation & ReplacementMost Popular | Equipment sizing for the home's load, Furnace, AC, or combined system replacement, Refrigerant line and ductwork connection check, Airflow balanced at commissioning | Homeowners whose system is aging, has needed repeated repairs, or where repair costs are stacking up against a unit near the end of its service life | In Johnson County, furnaces and central AC systems often age together. Replacing both at the same time as a combined project is frequently the more practical path. |
Call us at (816) 962-5932 to talk through your system, get a price on the phone, and find out what is available to schedule.
(816) 962-5932